MCX N94x/54x高度集成的多核MCU，具有片上加速器、智能外设和先进的安全性
硬件
快速参考恩智浦
板类型.
MCX A13x, 14x, 15x MCUs with Arm® Cortex® M33, Scalable Device Options, Low Power and Intelligent Peripherals
MCX A13x, A14x, A15x microcontrollers featuring an Arm® Cortex®-M33 core operate at up to 96MHz with high levels of integration and analog. They address a wide range of applications with scalable device options. The low-power and intelligent peripherals include timers that generate three complementary PWM pairs with deadband insertion, 4Msps 16b ADC with hardware windowing and averaging features. The innovative power architecture is designed to support high utilization of I/Os and power efficiency with a simple supply circuit in a smaller footprint.
The devices are supported by the MCUXpresso Developer Experience to accelerate embedded system development.
产品详情
框图
Features
Key Features
- Arm® Cortex®-M33 96MHz with 396 CoreMark (4.12 CoreMark/MHz)
- Up to 1MB Flash, up to 128KB SRAM, 8 KB SRAM with ECC
- All RAM can be retained down to Deep Power Down mode
- -40 °C to 125 °C temperature range
Core Platform
- Arm 32-bit Cortex-M33 CPU, with FPU and DSP extension instruction set, no TrustZone, no MPU
Memory
- Single-bank Flash: Up to 1024 KB Flash with ECC (support one bit correction and two bits detection)
- Flash minimum programming size is 16 bytes
- Support Flash Swap with 8 KB granularity
- Cache Engine with 4 KB RAM
- Up to 128 KB RAM, configurable as up to 8 KB with ECC (support single bit correction two bits detection)
- All RAM can be retained down to deep power down mode
Peripherals
- Analog
- Up to two single-ended 16-bit ADC with sample rate of 4.0 Msamples/sec in 12-bit mode, and 3.2Msamples/sec in 16-bit mode. Up to 32 ADC input channels with multiple internal and external trigger inputs
- One integrated temperature sensor per ADC
- One 12-bit DAC
- Two high-speed comparators with 8 input pins and a 8-bit DAC as internal reference, one comparator is functional down to deep power down mode, can be used as a wake-up source from low-power modes
- One OpAmp supports PGA
- Timers
- Up to five 32-bit standard general-purpose asynchronous timers/counters, each timer supports up to four capture inputs and four compare outputs; specific timer events can be selected to generate DMA requests
- Low power timer
- Frequency measurement timer
- Windowed watchdog Timer
- Wake timer
- Micro-tick timer (UTICK) that runs from the 1 MHz clock. This can wake up the device from reduced power modes up to deep sleep with Flash off, with extremely low power consumption
- 42-bit free running OS timer as a continuous time base for the system, available in any reduced power modes
- Communication Interfaces
- USB 2.0 full speed device controller with on-chip PHY supporting crystal-less operation in device mode
- Up to two LPSPI modules, supporting up to 50MHz operation frequency in master mode
- Up to four LPI2C supporting Standard, Fast, Fast+ and Ultra Fast modes
- Up to five LPUART, provides asynchronous, serial communication capabilities
- One I3C bus interface
- One FlexIO programmable as a variety of serial and parallel interfaces, including, but not limited to display driver and camera interface (depending on part number)
- One FlexCAN with FD (depending on part number)
- Advanced Motor Control Subsystem
- Up to two FlexPWM each with 3 sub-modules, providing 12 complementary outputs of PWM (no Nanoedge module)
- Up to two Quadrature Decoder (eQDC), provides interfacing capability to position/speed sensors used in industrial motor control applications
- Up to two AOI (AND/OR/Invert) module support up to 4 output trigger
MCUXpresso Developer Experience
-
MCUXpresso ecosystem support
- Selection of IDE choices
- Pin, clock, peripheral, security and memory config tools
- Security programming and provisioning tools
- Software development kit (SDK)
- Zephyr™ RTOS support
Security
- Device Life cycle management
- Flash read/write/execute permission protect by MBC and lockable
- 128-bit Universal Unique Identifier (UUID) per device in accordance to IETF’s RFC4122 version 5 specification
- Code Watchdog and glitch attack resistant keyed access (Glikey) support a security monitoring
Packaging
- 64LQFP, 10x10mm, 32QFN, 5x5mm and 48QFN, 7x7mm
部件编号包含： MCXA132VFM, MCXA132VFT, MCXA133VFM, MCXA133VFT, MCXA142VFM, MCXA142VFT, MCXA142VLH, MCXA143VFM, MCXA143VFT, MCXA143VLH, MCXA144VLL, MCXA144VMP, MCXA144VPJ, MCXA145VLL, MCXA145VMP, MCXA145VPJ, MCXA146VLL, MCXA146VMP, MCXA146VPJ, MCXA152VFM, MCXA152VFT, MCXA152VLH, MCXA153VFM, MCXA153VFT, MCXA153VLH, MCXA154VLL, MCXA154VMP, MCXA154VPJ, MCXA155VLL, MCXA155VMP, MCXA155VPJ, MCXA156VLL, MCXA156VMP, MCXA156VPJ.
相关产品
MCX C04x MCU搭载了Arm® Cortex® M0+，是带有经典外设的入门级MCU
MCX N23x高度集成的MCU，具有片上加速器、智能外设和高级安全功能
MCX C14x/24x/44x MCU搭载了Arm® Cortex® M0+，是入门级MCU，带有USB、段式LCD和经典外设
购买/参数
|
|
|
|
|
|
|
|---|---|---|---|---|---|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
文档
快速参考恩智浦 文档类别.
设计资源
软件
快速参考恩智浦 软件类型.
1-5 / 9 软件文件
-
应用示范软件
应用代码中心
-
BSP及设备驱动
MCUXpresso配置工具 - 引脚、时钟、外设
-
样品及快速入门软件
MCUXpresso软件开发套件(SDK)
-
调试及视觉化工具
FreeMASTER运行时调试工具
注意: 推荐在电脑端下载软件，体验更佳。