INPUTS Command

In FCS and CPU-Only Simulation mode, the INPUTS command opens the Simulated Port Inputs dialog box shown in the following figure. You may then use this box to specify the input states of port pins and IRQ.

Figure 1. Simulated Port Inputs Dialog Box
Simulated Port Inputs Dialog Box

When using In-Circuit Simulation mode, the INPUTS command shows the simulated input values for any applicable port.

Syntax 


  >gdi INPUTS
Example 


  >gdi INPUTS

Show I/O port input values.

Note: The IRQ pin state can be directly manipulated with the IRQ command. For example, IRQ 1 simulates a high state on the IRQ pin; likewise, IRQ 0 simulates a logic-low state on the IRQ pin.