Operational commands

The following commands are used to control access to the internal setup utility, to reset the Ethernet TAP probe, to stop, rather than reset the target system after connection, and to prepare the serial port to receive a new core image.

floader

Use the floader command when you need to reprogram the core software stored in the flash EPROM of the Ethernet TAP probe through the serial port. This command prepares the serial port for host floader initiation. When the load is complete, this command returns control to the shell and a new prompt is displayed. Do not use this command when reprogramming over the network.

Syntax

  floader

logout

Use the logout command to abort your telnet connection. Note that this command is not available from the serial console.

Syntax

  logout

reset

The reset command reboots the device. Note that when you reset the Ethernet TAP probe from a telnet session, you will lose your telnet connection to the internal setup utility. When this happens, simply open another terminal and reconnect after the Ethernet TAP probe has booted up.

Syntax

  reset

who

Determines if the Ethernet TAP probe is in use, and identifies who is using it.

Syntax

who