Configuring Ethernet TAP probe using netparam

Use the netparam command to select the network parameters:

• Address resolution protocol
• Dynamic routing method
• Static address resolution data
• Static routing tables
  CAUTION:
  netparam writes its settings into non-volatile flash memory on the Ethernet TAP probe. Each time you enter a netparam command, wait for the core> prompt to re-appear before entering the next command. The prompt indicates that the write is complete.

• Configuring dynamic IP address
  If you specify a hostname for the Ethernet TAP probe, the probe will attempt to register the host name with the DHCP server.
• Configuring static IP address
  If you do not have a DHCP server on your network or you prefer to manually configure your network settings, the Ethernet TAP probe is capable of storing its IP address and netmask in flash memory.
• Selecting dynamic or static routing
  Routers forward network traffic from one point on the network to another across these subnets.
• Changing existing route entry
  Before entering static routes, make a map of all gateway paths between the Ethernet TAP probe, as starting point, and each workstation that must have access to it.
• Entering static routes
  Before entering static routes, make a map of all gateway paths between the Ethernet TAP probe, as starting point, and each workstation that must have access to it.