Software uses several network ports to communicate with an Ethernet TAP. In case where the Ethernet TAP and host software are on the same network, you do not need to be aware of these ports. However, in case where an Ethernet TAP is located in a protected network, an administrator will need to provide access to these ports if you need to connect to the Ethernet TAP from another network. The table below list the ports used by the Ethernet TAP and a brief description of each port.
| Port Number | Description |
|---|---|
| 23 | Telnet access to configuration console |
| 1080 | Used by CodeWarrior to initialize the Ethernet TAP |
| 1081 | Used for firmware updates |
| 1082 | Telnet access to target serial port |
| 41474 | Used by CodeWarrior to control the Ethernet TAP |
| 53099 | Used by CodeWarrior to check Ethernet TAP status |