Configuring for Data Visualization

To configure your DSC project for data visualization:

  1. Open the Debug Configurations dialog box.
  2. Click the Trace and Profile tab.
  3. Check the Enable Data Visualization checkbox.

The options corresponding to Trace and Profile get disabled. This is because Data Visualization and tracing cannot be used simultaneously. Trace collection and Data Visualization sampling may be used together on the platforms which support reading target memory and registers while running. In this case, both checkboxes will be enabled and may be selected at the same time.

Figure 1. Trace and Profile Tab - DSC Architecture
Trace and Profile Tab - DSC Architecture

© 2014 Freescale Semiconductor, Inc. All rights reserved.