Overview
========
The DMA linked descriptors example is a simple demonstration program that uses the SDK software.
The purpose of this example is to show how much time to create the linked descriptors in
non-optimized and optimized method.

Toolchain supported
===================
- IAR embedded Workbench 8.20.1
- Keil MDK 5.24
- MCUXpresso10.1.11

Hardware requirements
=====================
- Micro USB cable
- LPCXpresso54608 board
- Personal Computer

Board settings
==============
No special settings are required.

Prepare the Demo
================
1.  Connect a micro USB cable between the host PC and the LPC-Link USB port (J8) on the target board.
2.  Open a serial terminal with the following settings:
    - 115200 baud rate
    - 8 data bits
    - No parity
    - One stop bit
    - No flow control
3.  Download the program to the target board.
4.  Either press the reset button on your board or launch the debugger in your IDE to begin running the demo.

